#16 Shield The .45 Knife Handle Shield 410SS .048" thick

$1.06

Shield for Knife Handle

These are waterjet cut from 410 stainless steel and are .048" thick.

You will see a slight tab burr on on side where the material was held in place when being cut. There is also a slight burr on the bottom. Clean up of these burrs is a minute or two work with sandpaper. Use these for ready made inserts in your knife handles.


Use the shield template (sold separately) to make your inlay slot along with a 3/32" needle burr.

You are purchasing 1 shield.

 

Add to Cart:

  • Model: Shield # 16 The .45
  • Shipping Weight: 0.01lbs


This product was added to our catalog on Sunday 13 December, 2009.

Your IP Address is: 38.107.191.116
Copyright © 2010 Zen Cart. Powered by Zen Cart