Power Twist Link Belt by Fenner Drive

Power Twist Link Belt by Fenner Drive

• ORDER 3 for 3 feet of belt! You will need 3 feet! Enter 3 for quantity!
  
• If you order 1, you only get 1 foot  of belt and that is enough for a bracelet.
• Did I mention you will need 3 feet and to enter 3?
  
• These belts are as good as you have read about.
• They reduce vibration, run smoother and cooler than typical belts.
  
• These are size A/4L which is the most common size for 1/2hp to 10hp motor power drive applications.
  
• Use these on your grinders, table saws or any where else you have an electric motor running a sheave or pulley that you want to run smoother and quieter.
• You can of course order any length you want, I just want to make sure you order enough to get your grinder (or other power tool) up and running...
  

NOTE: You will almost certainly need at least 2 feet and maybe 3 feet in length depending on your power train. You are ordering 1 foot at a time here so order 3 quantity for 3 feet in length.

I was skeptical about these belts until I tried them. They work. Do a google search and read different opinions. Even if your belted machine doesn't currently need a replacement, it will eventually and probably at the worst time. Have a Power Twist Link belt on hand and ready so you won't have any down time.

Order by the foot.

You will probably need at least 3 feet for most any application!

Tip-determine how much you need to order: You will almost certainly need at least 2 feet and most likely 3 feet depending on your power train. Draw out on paper 2 circles the size of the pulleys you will use (a 3 step will be a 4" circle and a 2" circle), figure at least 4" to 6" between the motor pulley and drive pulley. Use a string and lay it out around your drawing and then measure the string.